Table of Contents
Advertisement
The unattended object detection settings are
confirmed.
Note
Be sure to click the OK button to confirm the
settings. The setting will be cancelled if you do not
click the OK button.
12
When Preset position is selected for PTZ position,
perform settings for other preset positions.
Repeat steps 2 to 11 for each preset position.
13
Set Detection time, Alarm interval and Release
time in the Unattended object setting tab.
Unattended object setting Tab
Use this tab to set the alarm time for unattended object
detection.
Time setting
Unattended object detection requires the following three
kinds of time settings.
Detection time
Set the period of time from when an object appears in an
active window and stops or when an object in an active
window disappears until the point when that object is
regarded as an unattended object. An alarm will be
output if the specified period has elapsed.
You can set the time between 40 seconds and 12 hours.
Note
If Stay time for the tour function specified in the Preset
position menu (page 60) is shorter than Detection time,
the camera will move to the next preset position before
the object is regarded as an unattended object.
Alarm interval
You can repeat the alarm output in an interval of the
preset time after an object has been regarded as an
unattended object.
If you set Alarm interval to 5 minutes, for example, so
that an alarm will be output every 5 minutes repeatedly
after an unattended object is detected.
You can set the time between 1 and 6 hours.
Release time
Set the period of time required when the object once
regarded as an unattended object is regarded as a
background.
An alarm will no longer be output if the specified period
has elapsed as the object once regarded as an unattended
object is regarded as a background.
You can set the time between 1 and 12 hours.
Note
Set Release time to a larger value than Detection time.
OK/Cancel
See "Buttons common to every menu" on page 31.
Configuration Tab
Setting list
Lists the settings for each position: Moving object
detection, Unattended object detection, None.
Note
If you select Moving object or Unattended object in
the Common tab when no window is set to Active, None
is displayed in the list.
Setting the Object Detection Function — Object detection Menu
83
Advertisement
Table of Contents
