When You Discard The Camera - Sony IPELA SNC-RX550NP User Manual

<string> position. The maximum length of
<string> is 255 characters.
4) enaAuthTraps=<value>
Set the case value of "mib-2.snmp.snmp
EnableAuthenTraps.0" in the <string> position.
Type "1" (enable) or "2" (disable) in the <value>
position.
5) community=<ID>,r,
<communityName>,<IpAddressString>
Set the community attributes. <ID> describes the
setting identification number (1 to 8)
<communityName> describes the community
name to be set, and <IpAddressString> describes
the IP address of the host you allow access (0.0.0.0
for any host).
Example: To allow reading by any host in the "private"
community and having the ID number "2".
community=2,r,private,0.0.0.0
6) trap=<ID>,<communityName>,
<IpAddressString>
Set the attributes to send traps to. <ID> describes
the setting identification number (1 to 8),
<communityName> describes the community
name to send traps to, and <IpAddressString>
describes the IP address of the host to send traps to.
Example: To specify the destination of traps as the
public community and the ID number "1".
trap=1,public,192.168.0.101
7) delcommunity=<ID>
This parameter is used to delete the previous
community setting. <ID> describes the community
setting identification number (1 to 8).
8) deltrap=<ID>
This parameter is used to delete the previous setting
of the host to send traps to. <ID> describes the trap
setting identification number (1 to 8).
When you have finished changing the SNMP setting
information using the above parameters 1) to 8), check
the changed settings using an inquiry commands. If the
changed settings are OK, restart the SNMP using the
following CGI command.
SNMP restart command
<Method>
GET, POST
<Command>
104

When You Discard the Camera

When You Discard the
Camera
For environmental reasons, take out the lithium battery
from the camera and discard it appropriately.
1
Remove the eight screws illustrated below and
detach the bottom panel
.
2
Hold the board on which the lithium battery is
attached using long-nose pliers. Then, bend it in
the direction of the arrow illustrated below to
detach the battery.
WARNING (for service personnel only)
There is danger of explosion if batteries are mishandled.
Dispose of batteries properly in accordance with the
manufacturer's instructions and all applicable local
regulations.
Lithium
battery