Watching Tv - Panasonic Viera TH-65PX600 Operating Instructions Manual

INITIAL GUIDE SETUP for TV Guide
Configure Your VCR
5
Would you like to use the TV Guide On Screen system to control recording with your VCR?
Yes, set up VCR control
No, end setup
If you want to use TV Guide On Screen Listings to schedule recordings to your
VCR, answer "Yes, set up VCR control".
Additional screens ask you to
• Confirm the VCR and IR connections.
• Select the VCR brand.
• Test and confirm the VCR (remote control) code, if you choose "No" or "Test
this code again" when asked "Did your VCR stop playback of the tape?".
Follow the instructions on the screen to perform setup.
If you do not want the Guide to control recording to your VCR, answer "No, end
setup" and go to Step 6.
Complete Setup
6
The Helpful Information screen is displayed when you successfully complete
Guide setup.
Helpful Information
Congratulations on your TV Guide On Screen setup!
Within 24 hours after your TV is powered OFF, you should begin to get listings.
Press TV GUIDE on your remote:
If listings are not yet available, you'll see a TV Guide Setup Progress Screen.
If listings sre available, you'll see a listings grid.
(Note: It may take up to 6 days to get the full 8days of listings.)
To make sure you get the latest daily listings updates, remember:
TV - OFF
And don't forget to update your TV Guide On Screen Setup if you:
move to a new ZIP Code
change a service
add or remove a device
Just press TV GUIDE and choose the "Change system settings" option.
More information is a vailable at www.tvgos.com.
View Setup Progress Screen
7
The setup progress screen appears each time you enter the Guide prior
to receiving your initial eight days of show listings. To close the screen
press
Caution
•
In order to begin to receive your listings, power Off the TV when not in use. Within 24 hours, you will begin to
receive TV show listings. It may take up to six days to receive the full eight days of initial show listings.
14
Next
Back
Next
Back
or OK.

Watching TV

(Continued)
Insert the CableCARD™ when watching cable TV. (p. 9)
ok
select "Next"
select
ok
Note
•
Reselect "Cable" or
"Antenna" in "ANT
In" of "Auto program"
to switch the signal
reception between
cable TV and antenna.
(p. 12)
•
The channel number
and volume level
remain the same even
after the TV is turned
off.
Switch to TV mode
1
2 Turn power on
•
POWER button on
unit should be On.
Close TV Guide
3
- -
Select a channel number
4
up
or
down
To directly input the digital channel number
•
- When tuning a digital channel, press the PROG- button to
enter the minor number in a compound channel number.
example: CH15-1:
TV Guide open up
-
15