Rheem GHE80SU Use & Care Manual page 36

Status Menu
The Status screen provides information on the current
operating status, diagnostics and sensors. This screen
also provides information on the WiFi status.
120°
warm
Settings Status
By pressing the Status button, you will
be taken to a prompt showing the state
of your water heater's many features.
Status: Standby
Gas Line Press. Switch
Gas Valve State
Fan Prove Press. Switch
Air Intake Press. Switch
Exhaust Press. Switch
Current Fan Speed
Flame Current
wifi status
By selecting Wi-Fi status, you can
access the status of your water
heater's Wi-Fi and even set it up.
WI-FI STATUS: After selecting the Wi-Fi status function,
you will be brought to a prompt showing you the cur-
rent state of your water heater's Wi-Fi and the ability
to set-up your water heater's Wi-Fi.
wifi status
WiFi Device Status............
WiFi Signal Strength [dBm]....
Econer wifi SW Version........
WiFi Module SW Version........
MAC Address...................
SSID..........................
IP Address ...................
Subnet Mask...................
Gateway.......................
User Interface
Status: Standby
hot very hot
Disable
Service
Open
Closed
Open
Closed
Closed
0 RPM
0.0 uA
more
By selecting more, you can access
the temperatures of your water
heater, ECO switch state, and
auxiliary switch state.
Ready To Connect
0
RH-WIFI-02-01-05
14.76.36.P103
F0-03-8C-B3-C6-CC
wifi setup
Selecting the Wi-Fi setup function
will bring you to a prompt allow-
ing you to connect your water
heater to your home Wi-Fi.
MORE FUNCTION: Selecting the more function your heat-
er will bring you to a prompt showing you the current
temperatures of the lower/upper tank, Flue tempera-
ture, ECO switch state, and Auxiliary relay state.
Status: Standby
Upper Tank Temp
Lower Tank Temp
Flue Temperature
ECO Switch State
Auxiliary Relay State
Service Menu
The service screen provides information on the product
description, alarms, system health, and service alerts.
Alarm details can be found in the "Before You Call Ser-
vice" section of the manual.
In case there is an active alarm, the "Service" button
will blink on the home screen. Pressing the "Service"
button will show a new screen containing the active
alarms and alarm history.
120°
warm
Settings
By selecting the service function,
you will be taken to a prompt
giving you access to the heater's
alarms, health, and alerts.
Product Model Number:
Product Serial Number:
Software Version Number:
current alarm
alarms history
Current Alarms and Alarm
History allows you to
access any current alarms
that have been tripped and
view a list of previous
alarms.
36
159.8°
68.6°
92.7°
Closed
None
Status: Standby
hot very hot
Status
Service
service
WH-GHE1-00-00-86
system service
health alerts
System Health Service Alerts will allow
will show you the you to set how often you
status of the tank's want to be alerted to check
combustion health venting, clean the drain
and overall tank trap, replace the neutralizer,
health. and to drain and inspect
the tank.
Disable