Network Stack Configuration - Asus P10S-E/4L Manual

SATA Port 1–8
Port 1–8 [Enabled]
Allows you to enable or disable the SATA port.
Configuration options: [Disabled] [Enabled]
Mechanical Presence Switch [Enabled]
Allows you to enable or disable reporting if the port has an Mechanical Presence
Switch.
Configuration options: [Disabled] [Enabled]
Spin Up Device [Disabled]
Enable this option to start a COMERSET initialization sequence to the device on an
edge detect from 0 to 1.
Configuration options: [Disabled] [Enabled]
SATA Device Type [Hard Disk Drive]
Allows you to set whether the SATA port is connected to Solid State Drive or Hard Disk
Drive.
Configuration options: [Hard Disk Drive] [Solid State Drive]
Device Sleep [Disabled]
Allows you to enable or disable the mSata for RTD3.
Conifguration Options: [Disabled] [Enabled]
SATA DEVSLEP Idle Timeout Config [Disabled]
Allows you to enable or disable SATA DTIO Config.
Configuration options: [Disabled] [Enabled]
4.4.6

Network Stack Configuration

Network Stack [Disabled]
Allows you to enable or isable UEFI Network Stack.
Configuration options: [Disabled] [Enabled]
ASUS P10S-E/4L 4-37