Table of Contents
Advertisement
english
• Do not use any stands for mounting the tool
to a support.
• Do not disassemble or block any parts of the
fastener driving tool such as the contact trip.
• Prior to each operation check that the safety
and triggering mechanism is functioning
properly and that all nuts and bolts are tight.
• Do not use the tool as a hammer.
• Do not use the DCN660 or DCN661
– when changing from one driving location
to another involving the use of scaffoldings,
stairs, ladders or ladder-like constructions,
e.g., roof laths, etc.;
– when closing boxes or crates;
– when fitting transportation safety systems,
e.g., on vehicles, wagons, etc.
For exemptions check your local national
workplace regulations.
• Always check local workplace regulations.
• Never point any operational fastener driving tool
at yourself or at any other person.
• While working, hold the tool in such a way that
no injuries can be caused to the head or to the
body in the event of a possible recoil due to a
disruption in the energy supply or hard areas
within the work piece.
• Never actuate the fastener driving tool into free
space.
• In the work area, carry the tool at the workplace
using only one handle, and never with the
trigger actuated.
• Consider the conditions in the work area
Fasteners can penetrate thin work pieces or slip
off corners and edges of the work piece, and
thus put people at risk.
• Do not drive fasteners close to the edge of the
work piece.
• Do not drive fasteners on top of other fasteners.
Residual Risks
In spite of the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks cannot be avoided.
These are:
– Impairment of hearing.
– Risk of personal injury due to flying particles.
– Risk of burns due to accessories becoming hot
during operation.
– Risk of personal injury due to prolonged use.
38
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
Do not operate tool scaffoldings, ladders.
Length of nails.
Nail thickness.
Loading capacity.
Tool voltage.
Magazine angle: 20˚.
Visible radiation. Do not stare into light.
DATE CODE POSITION
The date code, which also includes the year of
manufacture, is printed into the housing.
Example:
2015 XX XX
Year of Manufacture
Important Safety Instructions for All
Battery Chargers
SAVE THESE INSTRUCTIONS: This manual
contains important safety and operating
instructions for compatible battery chargers (refer to
Technical Data).
• Before using charger, read all instructions and
cautionary markings on charger, battery pack,
and product using battery pack.
WARNING: Shock hazard. Do not allow
any liquid to get inside charger. Electric
shock may result.
WARNING: We recommend the use of
a residual current device with a residual
current rating of 30mA or less.
Advertisement
Table of Contents
