Table of Contents
Advertisement
Appendix A Frequently Asked Questions
Problem
The Connection Setup screen
does not appear after I update
the phone files on my handheld.
My passkey is rejected when I
attempt to pair (or bond) my
mobile phone with my
handheld.
My handheld cannot connect to
my mobile phone.
My phone connection drops
before I finish using it.
I get an error message when I try
to dial a phone number using
my handheld.
20
Solution
Tap the Home icon
1.
Select the Phone Link icon
2.
Tap the Phone Connection box.
3.
Some mobile phones require that you enter the passkey
within a specific time frame. Make sure you have a passkey
in mind and that you enter it immediately when prompted.
If your passkey is rejected, your phone may have a
preassigned passkey; see the documentation included with
your phone for information. The documentation might
refer to a Bluetooth connection as a Bluetooth pair or a
Bluetooth link.
Use the following steps to test the connection:
Tap the Home icon
1.
Select the Phone Link icon
2.
Tap Connect.
3.
If the connection is successful, open the application that
4.
requires the connection and complete the desired task.
If the connection is not successful, do the following:
– Make sure the Connection for your mobile phone is
selected in the Connection Preferences screen and in the
Phone Preferences screen.
– Make sure that Bluetooth is enabled on both your phone
and your handheld and that the power is on.
You need to increase the Idle timeout setting on the
Network Preferences Details screen. For instructions,
see "Adding detailed information to a network service
profile" in the Handbook for Palm™ Tungsten™ T Handhelds.
Make sure that the proper phone driver is installed on your
handheld. For instructions, see
from the Internet to your handheld"
handbook.
Check the Phone Preferences screen and make sure the
correct phone connection is selected.
.
.
.
.
"Downloading phone files
in
Chapter 1
of this
Advertisement
Table of Contents
