Table of Contents
Advertisement
Kits
Crestron TSW-550/750/1050-TTK & TSW-550/750/1050-SMK
Installation
To attach a TSW-550, TSW-750 or TSW-1050 touch screen to the
TSW-550/750/1050-TTK and mount it using the optional swivel mount
kit, refer to the following procedures.
Preparing the TSW-550/750/1050-TTK
The TSW-550/750/1050-TTK comes with parts for routing device
cabling through either the back of the unit or through the bottom for a
neat appearance.
Cable Routing Through Bottom of TSW-550/750/1050-TTK
Out of the box, the TSW-550/750/1050-TTK comes with a plastic cover
on the rear of the unit, allowing the LAN cable to pass out through the
bottom, such as when the TSW-550/750/1050-TTK is attached to the
TSW-550/750/1050-SMK Swivel Mount Kit (sold separately).
Cable Routing Through Rear of TSW-550/750/1050-TTK
For routing a single CAT5 cable through the rear of the
TSW-550/750/1050-TTK, the plastic cover on the rear must be replaced
with the strain relief (2033955 on black models or 2033954 on white
models) that is included with the TSW-550/750/1050-TTK.
To replace the plastic cover with the strain relief, perform the following
procedure:
1. Before the plastic cover can be removed, the metal bracket inside
10 • Kits: TSW-550/750/1050-TTK & TSW-550/750/1050-SMK Installation Guide – DOC. 7411C
the TSW-550/750/1050-TTK must be removed. It is held in place
by two screws entering the bottom of the unit. Remove these
screws, then remove the metal bracket. Refer to the following
illustrations.
Advertisement
Table of Contents
