Advertisement
5
Installing the Control Box
Parts needed for this procedure:
1
Control box assembly
2
Carriage bolt (3/8 x 7/8 inch)
2
Locknut (3/8 inch)
3
Cable tie
1
Adhesive cable tie
Procedure
1.
Route the cables between the control box
and discharge chute as shown in
avoid damaging the cables through the entire
height-of-cut range.
Important:
Ensure that you route the cables
away from the front of the deck-lift pedal as
shown in
Figure 8
the cables.
Figure 8
so that you do not damage
Figure 8
2.
Remove the self-threading screw from the right
motion-control cover
Retain the self-threading screw.
to
1. Right motion-control cover
3.
Remove the 4 shoulder screws securing the
right side pod
Retain the 4 shoulder screws and right side pod
for later installation.
4.
Remove the right side pod
g349011
1. Right side pod
7
(Figure
9).
Figure 9
2. Self-threading screw
(Figure
10).
(Figure
10).
Figure 10
2. Shoulder screw
g349074
g345495
Advertisement
