Homelite HOMHT02 Operator's Manual page 13

CLEANING THE HEDGE TRIMMER
 Make sure the switch trigger is locked out in the off posi-
tion.
 Slide the scabbard over the blade.
 Clean dirt and debris from the body of the hedge trimmer,
using a damp cloth with a mild detergent.
NOTE: Do not use any strong detergents on the plastic
housing or the handle. They can be damaged by certain
aromatic oils such as pine and lemon, and by solvents
such as kerosene.
 Moisture can cause a shock hazard. Wipe off any moisture
with a soft dry cloth.
 Use a small brush or the air discharge of a small vacuum
cleaner brush to clear dust or debris from the air vents
on the motor housing.
STORING THE HEDGE TRIMMER
See Figure 8.
 Clean the hedge trimmer thoroughly before storing. Store
the hedge trimmer in a dry, well-ventilated place that is
inaccessible to children. Keep away from corrosive agents
such as garden chemicals and de-icing salts.
 Always place the scabbard on the cutting blades before
storing.
BATTERIES
This product is equipped with a lithium-ion rechargeable
battery. Length of operation from each charging will depend
on the type of work you are doing.
The battery in this product has been designed to provide
maximum trouble-free life. However, like all batteries, it will
eventually wear out.
To obtain the longest possible battery life, we suggest
the following:
 Remove the charging cable from the product once it is
fully charged and ready for use.
For product storage longer than 30 days:
 Store the product where the temperature is below 80°F
and away from moisture.
 Store product in a 30%-50% charged condition.
 Every six months of storage, charge the product as normal.
This product has a Two-year Limited Warranty for personal, family,
or household use (90 days for business or commercial use).
For warranty details, visit www.homelite.com
MAINTENANCE
or call (toll free) 1-800-242-4672.
Page 11 — English
BATTERY PACK REMOVAL AND
PREPARATION FOR RECYCLING
 Drain the battery by running the tool until it shuts off.
 Look for the Phillips head screws near the charging port
to locate the battery compartment door.
 Unscrew the screws and remove the battery compartment
door.
 Pull the battery out of the tool and separate it from the
two wire connectors.
 Apply tape over the ends of the wire connectors for bat-
tery disposal.
To preserve natural resources, please recycle or dispose of
batteries properly.
This product contains lithium-ion batteries.
Local, state or federal laws may prohibit dis-
posal of batteries in ordinary trash.
Consult your local waste authority for infor-
mation regarding available recycling and/or
disposal options.
WARNING:
Upon removal, cover the battery pack's terminals with
heavy-duty adhesive tape. Do not attempt to destroy or
disassemble battery pack or remove any of its compo-
nents. Lithium-ion batteries must be recycled or disposed
of properly. Also, never touch both terminals with metal
objects and/or body parts as short circuit may result.
Keep away from children. Failure to comply with these
warnings could result in fire and/or serious injury.