RAPIDPoint 500/RAPIDPoint 500e Configuration Guide
1 Introduction
This manual describes the use of the UniPOC
configure the RAPIDPoint
Please read this configuration guide for step-by-step instructions and illustrations on how to configure the
devices prior to placing them in service.
2 Intended Use
This software allows you to configure and use the RAPIDPoint
™
UniPOC
Point of Care Data Management System. This product is not for diagnostic use.
3 Instrument Configuration Pages
Important: Configuration settings can change based on the UniPOC application version and device driver
pack versions installed. For example, a device driver pack may be updated to support a new or changed
configuration setting but if you are using an older version of the UniPOC application that does not support
the change, you will not see the updated configuration setting in the UI.
The following Instrument Configuration pages are described in this manual.
•
Download Options
•
Instrument Settings
RAPIDPoint 500/RAPIDPoint 500e Configuration Guide
™
®
®
500 and RAPIDPoint
11555620, Rev. A, 2020-09
Point of Care Data Management System software to
500e device.
®
500/RAPIDPoint
®
500e device with the
Page 4/8