Ibanez MU2 - Metronome Tuner Manual

Caution

1. To avoid short circuit, electric shock, or malfunction
   Do not disassemble or attempt to repair this unit. Do not place this unit in locations of high temperature or high humidity (such as nearby heating equipment, in direct sunlight, in a bathroom, or on a wet floor).
   Do not place this unit where it will be subjected to heavy vibration.
   Do not place this unit in dirty or dusty conditions.
   Do not operate this unit with wet hands.
2. To avoid damage
   Do not apply excessive force to the switches or other controls. Do not drop this unit.
3. Cleaning
   Do not use thinner, alcohol, or other solvents to clean this unit.
4. To prevent battery failure
   Remove the battery if you won't be using this unit for an extended period of time.

Features and Functions

1. POWER/MODE BUTTON
   To power On/Off, hold this button for more than 1 sec. Pressing this button shifts the mode between tuner and metronome when MU2 is on.
2. INST. BUTTON
   In tuner mode, The tuning mode switches in following order.
   Chromatic - Guitar - Bass - Ukulele
3. FLAT BUTTON
   In tuner mode, dropped tuning can be set. You can drop the tuning by 1 semitone each time this button is pressed. This function is disabled when the tuner is in chromatic mode.
4. RHYTHM/VOLUME BUTTON
   In metronome mode, the rhythm can be changed by tapping this button.
5. CALIB TEMPO BUTTON
   Calibration setting can be adjusted between 430 - 450Hz with this button in Tuner mode. Tempo can be set from BPM 30 - 250 with this button in Metronome mode.

Operation

[Tuner]
Turn on the power and set the mode in Tuner mode by tapping POWER/MODE button. Set the instrument to be tuned with INST. Button. Set the drop tuning with FLAT Button and Calibration with button if desired. If the pitch of your instrument is more than 50 cents away from the correct pitch, tune your instrument until the correct note name appears in the LCD. If the pitch is within 50 cents of the correct pitch, watch the needle of the meter and tune your instrument from lower pitch so that the needle is at the "0" position. When the tuner needle stops at "0" the center LED will light; your instrument is tuned correctly.
Acoustic Guitar and Ukulele also can be tuned with the built-in Mic.

[Metronome]
Turn on the power and set the mode in Metronome mode with tapping the POWER/MODE button. The metronome will start running automatically. Tap/Hold the RHYTHM/VOLUME Button to set the rhythm of metronome and volume of the beat.
Set tempo with Button. Press the POWER/MODE button or switch to Tuner mode to stop the metronome.

Replacing Battery

1. Turn the power off.
2. Slide and open the battery cover.
3. Replace the batteries (AAA x 2) and set the battery cover.

Specification

Power Supply: AAA x 2 (3V)
[Tuner]
Input: MIC 1/4' JACK
Tuning range: A0 (27.5Hz) - C8 (4,186Hz)
Calibration: A4 = 430 - 450Hz
[Metronome]
Tempo: BMP 30 - 250 Rhythm:

• Design and specifications are subjected to change without notice for improvement of the product.