Ibanez PU3 - Clip-On Tuner Manual

Also See for PU3:

Owner's manual (4 pages)

Owner's manual (4 pages)

Table of Contents

Contents

1 Caution
2 Appearance
3 Operation
4 Replacing battery
5 Specifications
6 Documents / Resources
- 6.1 Download manual

Ibanez PU3 - Clip-On Tuner Manual

Caution

To avoid short circuit, electric shock, or malfunction
Do not disassemble or attempt to repair this unit. Do not place this unit in locations of high temperature or high humidity (such as nearby heating equipment, in direct sunlight, in a bathroom, or on a wet floor). Do not place this unit where it will be subjected to heavy vibration. Do not place this unit in dirty or dusty conditions. Do not operate this unit with wet hands.
To avoid damage
Do not apply excessive force to this unit. Do not drop this unit.
Cleaning
Do not use thinner, alcohol, or other solvents to clean this unit.
To prevent battery failure
Remove the battery if you won't be using this unit for an extended period of time.

Appearance

Operation

The tuner turns on automatically when it is clipped onto the headstock, and goes off automatically when it is removed.
The tuner will automatically turn off after 5 minutes if left on the headstock.
When it is in tune, only the blue indicator on center will flash up. When it is lower than the target pitch, the red indicator on the left side will flash up. When it is higher, the yellow indicator on the right side will flash up.

Replacing battery

When the LCD becomes dim, please replace the battery promptly.
The power must be turned off while the battery is replaced.
Make sure the polarity when replacing the battery ((+) mark should face up).

Specifications

Tuning mode: Chromatic
Tuning notes: A, A#, B, C, C#, D, D#, E, F, F#, G, G#
Tuning range: A0 (27.5 Hz) - C8(4186 Hz)
Calibration: A4 = 440 Hz
Accuracy: ±1cent
Power supply: Lithium battery (CR2032) x 1
Dimensions: 48(W) x 44(D) x 27(H) mm
Weight: 24g (Including battery)

* Design and specifications are subject to change without notice for improvement.