Advertisement
RAIN COLLECTOR: FEATURES
a.
Antenna
-Transmits signal to main unit
b.
Cross
- To level the rain collector
BATTERY INSTALLATION: MAIN UNIT
The main unit uses 2 UM-3 or AA alkaline batteries.
1. Unscrew the battery door at the bottom of the unit.
2. Remove the battery door and insert batteries in accordance
with the polarities as indicated.
3. Select the display unit by the [IN/MM] switch.
4. Replace the battery door and fasten the screw.
Battery
door
BATTERY INSTALLATION & SETTING
UP: RAIN COLLECTOR
The Rain Collector uses 2 UM-3 or AA alkaine batteries.
a
b
1. Remove the screws on the Rain collector as indicated in the
diagram and insert the batteries in accordance with the
polarities shown.
2. Remove the fiber tape from the Rain Collector assembly.
3. Position the main unit and rain collector within effective
range of each other (up to 100 feet).
4. Place the rain collector on a level surface. Add a few drops of
water; if the water collects at the center of the cross, the
collector is level.
Not Level
5. If collector is not level, rotate the metal ring(s) on the feet
of the collector to adjust and level.
6. Press the [RESET]
operation.
7. Press [SINCE] to display the default start date. Press and
hold to reset the start date to current date.
2
Level
Metal Ring
button on the main unit to initiate
Advertisement
