Table of Contents
Advertisement
HOW TO READ THE KINETIC WAVE
DISPLAY
The kinetic wave display shows the signal receiving status of the
main unit. There are three possible forms:
The unit is in searching mode.
Transmission data are securely
registered.
No signal received in search mode.
REMOTE SENSOR SCANNING
The unit can be set to automatically scan and display readings from
the remote sensors and indoor readings. When the remote-sensor
scanning mode is active, the display will show the readings from
one channel for about 4-second and then proceed to the next channel
display.
To activate the remote-sensor scanning mode:
• Press and hold [CHANNEL] for 2 seconds.
To deactivate the remote-sensor scanning mode:
• Press either [CHANNEL], [MEMORY], [HI/LO], [
b122hga-e.p65
COMFORT LEVEL INDICATORS
The comfort level indicators COM, WET or DRY will tell you if the
curent environment is comfortable, too wet or too dry.
The comfort indicator will appear on the display when the following
conditions are satisfied:
Indicator
displays
on the unit
20°C to 25°C
(68°F to 77°F)
COM
-5°C -+ 50°C
(23°F - 122°F)
WET
-5°C -+ 50°C
(23°F - 122°F)
DRY
Less than
No
20°C( 68°F)
Indicator
or More than
25°C (77°F)
], [ON/OFF]
(TEMP % RH AL)
7
7
Shows that the
Temperature
Humidity
Current
Range
Range
Environment
Ideal range for
40%RH-
both relative
70%RH
humidity and
temperature
OVER-
Contains excess
70%RH
moisture.
Contains
Below
inadequate
70%RH
moisture
40%RH
to
No comment
70%RH
08/10/2001, 12:17 PM
Hide quick links:
Advertisement
Table of Contents
