Table of Contents
Advertisement
HOW TO READ THE KINETIC WAVE
DISPLAY
The kinetic wave display shows the signal receiving status of the
main unit. There are three possible forms:
The unit is in searching mode.
Transmission data are securely
registered.
No signal received in search mode.
REMOTE SENSOR SCANNING
The unit can be set to automatically scan and display readings from
the remote sensors and indoor readings. When the remote-sensor
mode is active, the display will show the readings from one channel
for about 4-second and then proceed to the next channel display.
To activate the remote-sensor scanning mode:
• Press and hold [CHANNEL] for 2-seconds.
To deactivate the remote-sensor scanning mode:
• Press either [CHANNEL], [MEMORY], [HI/LO], [ " " " " " ], [ON/OFF]
(TEMP % RH AL)
7
THE COMFORT-LEVEL ICONS
The comfort level indicators COMFORT, WET or DRY will tell you
if the curent environment is comfortable, too wet or too dry.
The comfort indicator will appear on the display when the follow-
ing conditions are satisfied:
Indicator
Temperature
displays
Range
on the unit
20°C to 25°C
(68°F to 77°F)
COMFORT
-5°C -+ 50°C
(23°F - 122°F)
WET
-5°C -+ 50°C
(23°F - 122°F)
DRY
Less than
No
20°C( 68°F)
Indicator
or More than
25°C (77°F)
Shows that the
Humidity
Current
Range
Environment
Ideal range for
40%RH-
both relative
70%RH
humidity and
temperature
OVER-
Contains excess
70%RH
moisture.
Contains
Below
inadequate
70%RH
moisture
40%RH
No comment
to
70%RH
Advertisement
Table of Contents
