Ariens 938001-004 Service Manual page 19

Install cable clamp onto remote deflector cable 25"
from handlebar and at the start of the black protective
covering (reference G), see Figure 13. The hole for the
clip should be in the down position. Attach the clip to
the engine blower housing with the self-tapping screw.
Excess cable should be pulled up and out of blower
behind discharge chute (reference H).
Reinstall fuel tank into Sno-Thro with hardware
removed earlier, place cable tie around fuel tank neck
with green ignition wires. Check location of green
ignition wires to chute crank gear for proper clearance
(reference 1) see Figure 12.
ref. K
cable tie
Right side photo of cable routing and anchor point.
Figure 13
Rear photo of cable routing and anchor points.
Figure 14
8 - 19
On 938004, the electric start cable will need to be held
in place with a cable tie to clear chute crank gear. Drill
a 1/4" hole by measuring 1/4" down and out 1/4" from
recess in center of Sno-Thro frame (reference J), see
Figure 14.
Attach cable ties in the proper locations shown in the
photos as references K, L, and M. Recheck cable and
wiring routings before reinstalling engine cover. Return
machine to stock or customer.
ref. L
cable tie
ref. G
install cable clamp
ref. D
drill 1/8" hole
ref. J
drill 1/4" hole