Honeywell Farenhyt Series Manual page 12

Introduction
Type of Device
Other Modules
ECS Modules
Wireless
12
Model
5824 Serial/Parallel Allows a printer to be attached for the system for on-site event logging. Four maximum
Printer Interface Module per system.
5815XL (Rev H or above) Allows up to 127 SD devices to be added to the system. The number of 5815XL
SLC Expander modules that can be added to the system is limited only by the maximum number of
SBUS devices. However the maximum point count is limited to 254 per panel. Supports
SD protocol devices only.
6815 SLC Expander Supports System Sensor Devices (IDP or SK) only. Each 6815 supports up to 159 IDP
or SK sensors and 159 IDP or SK modules. Maximum point count is 300 per panel.
RPS-1000 (Rev F or Provides additional power, six Flexput circuits,
higher) Intelligent Power and two Form C relays.
Supply
5496 (Rev F or above) Add 4 Notification/Auxiliary power circuits with
NAC Expander each 5496 Intelligent Power Module
RA-2000 Remote LCD 4x 40 Remote LCD annunciator, can be used in any combination, up to a total of 16
Annunciator devices on one panel.
RA-100 Remote LCD 4 x 20 Remote LCD annunciator, can be used in any combination, up to a total of 16
Annunciator devices on one panel.
RA-1000 Remote LCD 4 x 20 Remote LCD annunciator, can be used in any combination, up to a total of 16
Annunciator devices on one panel.
5860TG and 5860TR trim ring kits for surface mounting the RA-1000 annunciator. 5860TG is gray; 5860TR is
Trim Ring Kits red.
5865-3 and 5865-4 LED LED annunciator can display up to 30 LEDs (15
Annunciator red and 15 yellow). 5865-4 has key switches for
silence and reset, and a system trouble LED.
5880 (Rev C or above) Driver for up to 40 LEDs. Interfaces with
LED I/O Module customized annunciator boards. In addition the
5880 has eight generic switch input points.
5883 General Purpose Provides 10 Form C relays. Designed to be driven by the 5880. Up to four, 5883
Relay Module modules can be used with each 5880 module.
SK-NIC Network Interface Card
ECS-NVCM Network Voice Control Module
ECS-VCM Voice Control Module
ECS-SW24 24 switch expander
ECS-50W 50 watt audio amplifier
ECS125W 125 watt audio amplifier
ECS-CE4 Provides 4 additional audio circuits for the ECS-
50W or ECS-125W.
ECS-RVM Remote Voice Module
ECS-DUAL50W Dual Channel amplifier
ECS-50WBU Backup daughter card
ECS-INT50W 50 wall internal amplifier
ECS-LOC Local Operating Console
WIDP-WGI/WSK-WGI Wireless Gateway
WIDP-PHOTO/WSK- Wireless Photoelectric Smoke Detector
PHOTO
Wireless multi-criteria photoelectric smoke
WIDP-ACCLIMATE
detector
WIDP-HEAT-ROR/WSK-
Wireless Rate of Rise Heat Detector
HEAT-ROR
WIDP-HEAT/WSK-HEAT Wireless 135° Fixed Heat Detector
WIDP-MONITOR/WSK-
Wireless Addressable Monitor Module
MONITOR
WIDP-RELAY/WSK- Wireless Addressable Relay Module
REALY
B210W 6" wireless base
Table 1.1 IFP-300 Compatible Products (Continued)
Description
IFP-300 Series Manual — P/N LS10145-001SK-E:C 4/6/2022
Compatible Products
RPS-1000 and 5496 modules can be
used in any combination, up to a total
of 16 on one system.
5865-3, 5865-4, and 5880 can be
used in any combination, up to a total
of eight devices on one panel.
Refer to LS10172-001SK-E
Refer to the ECS Series Installation
Manual P/N 151455for more
information on these accessories.
Refer to the SWIFT Wireless
Installation Manual
P/N LS10036-000FH-E for more
information on these accessories.