Table of Contents
Advertisement
7.
Remove the three (3) screws from both left and right sides of the server system
chassis, then remove the metal plate.
The illustration below only shows one side of the server system chassis, but the screws on
the other side should be at the same place.
8.
Align the inner rails with the studs on both sides of the server system, install the inner
rails to the server system, then slide the inner rails toward the rear of the server system
until it locks in place.
9.
Secure the inner rails on both sides of the server system using the #6-32X4L screws.
3-8
Metal plate
Chapter 3: Installation Options
Advertisement
Table of Contents
