Step 10. Connecting The Power Cables - IBM eserver 7210 Setup And Operator Manual

RS/6000 and pSeries Systems Only
The following attachment configuration examples are valid only for RS/6000 or
pSeries host system connection.
Figure 6. Example of Attaching Multiple Devices, with the Single Connector Device as the
First Device in the Sequence of External Devices
Figure 7. Example of Attaching Multiple Devices, with the Dual Connector Device as the First
Device in the Sequence of External Devices
Notes:
1. The terminator and the SCSI bus cable can be connected to either the top or
2. When attaching the 7210 DVD-RAM Drive to the host system, use the
3. Only one terminator is required to terminate the SCSI bus. You do not need to

Step 10. Connecting the Power Cables

To connect the power cables, do the following:
1. DANGER
2. __ Plug the power cables for all external devices and the system unit into
3. __ Turn on the power to all of the external devices.
10
7210 DVD-RAM Drive Setup and Operator Guide
bottom SCSI connector on the 7210 DVD-RAM Drive.
terminator that was shipped with the 7210 DVD-RAM Drive.
use the terminator shipped with the 7210 DVD-RAM Drive if a terminator has
been previously installed.
An electrical outlet that is not correctly wired could place hazardous
voltage on metal parts of the system or the products that attach to the
system. It is the customer's responsibility to ensure that the outlet is
correctly wired and grounded to prevent an electrical shock. (RSFTD201)
__ Plug the 7210 DVD-RAM Drive power cable into an electrical outlet.
electrical outlets.