Table of Contents
Advertisement
SYSTEM menu
Submenu
Language
Projector Mode
Menu Settings
High Altitude
Mode
Auto Input
Search
Password
26
Menu Functions
Sets the language for the On-Screen Display (OSD) menus.
See
"Choosing a location"
•
Menu Display Time
Sets the length of time the OSD will remain active after your last key press.
•
Menu Position
Sets the OSD menu position.
The mode is for operation in areas like high altitude or high temperature
environments. Activate the function when your environment is between 1500
m–3000 m above sea level and ambient temperature is between 0°C–30°C.
Operation under High Altitude Mode may cause a higher decibel operating
noise level because of increased fan speed necessary to improve overall
system cooling and performance.
If you use this projector under other extreme conditions excluding the above, it
may display auto shut-down symptoms, which is designed to protect your
projector from over-heating. In cases like this, you should switch to High
Altitude Mode to solve these symptoms. However, this is not to state that this
projector can operate under any and all harsh or extreme conditions.
Sets whether the projector searches automatically for input sources.
Select On to enable the projector to scan for input sources until it acquires a
signal. If the function is set to Off, the projector will select the last used input
source.
For security purposes and to prevent unauthorized use, you may set up
password security for the projector. This limits use of the projector to only those
who know the correct password. If you enter an incorrect password 5 times in
succession, the projector will automatically shut down in a short time.
You will be inconvenienced if you enable this function yet forget the password
somehow. Do make a note of your password, and keep the note in a safe
place for later recall.
You will be asked to set a new password if no password has been set before.
As the on-screen display indicates, the 4 arrow keys ( / / / ) respectively
represent 4 digits (1, 2, 3, 4). Use the arrow keys to set a 6-digit password. The
digits display as ****** when you enter them.
•
Change Password
You will be asked to enter the current password before changing to a new one.
•
Power On Lock
You will be asked to enter the current password before changing the setting.
Once a password has been set and the power on lock is enabled, the
projector cannot be used unless the correct password is entered every time
the projector is started.
If you forget the password, seek help from the local JVC service center. You
may be required to provide proof of purchase documentation to verify that
you are an authorized user of the projector.
Functions and Descriptions
for details.
Advertisement
Table of Contents
