Table of Contents
Advertisement
Submenu
Power Settings
12V Trigger
INFORMATION menu
Submenu
Input
Resolution
MaxCLL / FALL
Color System
IP Address
MAC Address
Firmware
Version
Low Latency
Mode
S/N
Some information is given only when certain input sources are in use.
30
Menu Functions
•
Auto Power Off
Prevents unnecessary projection when no signal is detected for a long time.
See
"Setting Auto Power Off"
•
Sleep Timer
Set the timer to turn off the projector. A confirmation message will pop up to
confirm turning off the projector when the timer counts down to zero.
•
Power Saving
Light source will enter low energy mode if there is no signal for 5 minutes.
There is one 12V trigger that works according to your needs for installation
scenarios. Two selections are available:
•
Off: If this is selected, the projector will not send electronic signal out
when it is turned on.
•
On: The projector will send a low to high electronic signal out when it is
turned on, a high to low signal out when it is turned off.
Displays the current signal source.
Displays the native resolution of the input source.
Displays the Maximum Content Light Level detected and the Maximum Frame
Average Light detected.
Displays input system format.
Displays the current IP Address.
Displays the current MAC Address.
Displays the firmware version of your projector.
Displays the current Low Latency Mode.
Displays the serial number of your projector
Functions and Descriptions
for details.
Functions and Descriptions
Advertisement
Table of Contents
