Advertisement
The electrode, and especially the welding rods become very hot during welding. Exercise extreme caution to
prevent burns to yourself or others.
NOTE: Read and adhere to all warnings and instructions in the instruction manual provided by the
manufacturer of the welder being used.
Your Compact Bender will require complete assembly prior to operation. It is important that you read the entire
manual to become familiar with the unit BEFORE you use the Compact Bender. Before assembling your
Compact Bender be sure that you have all parts described in the Parts List on page 9.
When assembling your Compact Bender, it will be helpful to refer to each of the operational Figures as well as
to the Parts List and Assembly Diagrams on pages 9-11.
Mounting Surface: The mounting surface must be flat, level and capable of supporting the weight of the
Compact Bender combined with the materials to be worked with.
Step 1)
Bolt the Stand (#11) to a flat, stable floor surface that is capable of supporting
the weight of this tool and the various workpieces to be used.
Step 2)
Place the three (3) Mounting Spacers (#13) over each hole on the top of the Stand (#11)-see
Figure 1.
Step 3)
Place the Ring Assembly/Die Receiver (#10) over the three Mounting Spacers (#13) so that
the two holes on the Ring Assembly (#10) line up with the corresponding Mounting Spacers
(#13). Insert two (2) Mounting Bolts (#16) through the Ring Assembly (#10), Mounting Spacer
(#13) and Stand (#11). Tighten on Nuts (#14)-see Figure 1.
#31980
WARNING: WELDING PRECAUTIONS (Continued)
Assembly
Figure 1-Assembly
Mounting
Page 4
Advertisement
