Advertisement
The Letter "B"
Three blanks are required for this letter:
•
8-7/8" long
•
8-7/8" long
•
6" long
3rd
2-3/4"
Step 1)
Using chalk mark off 2-3/4" in from each side. Mark off one inch from the first chalk mark on
each side.
Do the same for the second 8-7/8" blank.
Step 2)
Set the Right Angle Bend Attachment into place.
Step 3)
Set the stock in the Bender so that the Right Angle Bend Attachment will bend at the first
chalk mark. Bend to 45 degrees.
Step 4)
Move the stock to the second chalk mark and bend to 45
.
Step 5)
Pull the stock out of the bender and insert the stock with the opposite end in the
bender. Make the 3rd bend at 45 degrees.
Step 6)
Slide the stock to the fourth position and bend to 45
.
Step 7)
Weld the completed two 8-7/8" pieces together, these will be the curves in the letter "B". Weld
on the 6" piece to form the spine of the letter.
The Letter "C"
One blank is required for this letter:
•
14" long
3rd
3-3/4"
1-1/4"
Step 1)
Using chalk, mark off 3-3/4" in from each side.
Step 2)
From the inside mark, measure in another 1-1/4" and mark it off from each side.
Step 2)
Set the Right Angle Bend Attachment into place.
Step 3)
Set the stock in the Bender so that the Right Angle Bend Attachment will bend at the first
chalk mark. Bend to 45
.
Step 4)
Make a bend at your second chalk mark to 45
Step 5)
Take the stock out of the Bender. Insert the second side. Repeat steps 3 and 4.
#31980
4th
2nd
1st Bend
1"
1"
2-3/4"
2nd
1st Bend
4th
3-3/4"
1-1/4"
°.
°.
°.
°.
Page 17
Advertisement
