Advertisement
The Letter "D"
Two blanks are required for this letter:
•
12-1/2" long
•
6" long
3rd
4th
3"
1-1/4"
Step 1)
Using long blank, mark off 3" in from each side. Then measure in and mark off 1-1/4" on each
side.
Step 2)
Make a bend to 45
mark and bend to 45
Step 3)
Pull out the stock and insert the opposite end. Repeat step 2.
Step 4)
Make certain that both ends of the "D" are equal.
Step 5)
Weld on the 6" piece to form the spine of the letter.
The Letter "E"
Two blanks are required for this letter:
•
14-9/16" long
•
2-1/2" long
2nd
4-1/2"
Step 1)
Using the long blank, mark off 4-1/2" in from each side.
Step 2)
Make a bend to 90
Step 3)
Take out the stock and insert the other end. Make a bend to 90
Step 4)
Make certain that the top and bottom of the "E" are parallel.
Step 5)
Weld on the 2-1/2" piece at the center of the E.
Step 6)
Smooth away any sharp edges using a grinder or sanding.
#31980
1st Bend
2nd
3"
1-1/4"
°
at the first chalk mark. Slide the stock to the second
°
.
1st Bend
4-1/2"
°
at the first chalk mark.
°
at the first chalk mark.
Page 18
Advertisement
