Advertisement
The Letter "F"
Two blanks are required for this letter:
•
10-1/2""
•
2-1/2"
Step 1)
Using the long blank, mark off 4-9/16" in from one side.
Step 2)
Make a bend to 90
Step 3)
Weld on the 2-1/2" piece at the center of the F.
The Letter "G"
Two blanks are required for this letter:
•
14" long
•
3" long
3-3/4"
Step 1)
Using chalk, mark off 3-3/4" in from each side of the long blank. Mark off one inch on each
side as shown above.
Step 2)
Set the Right Angle Bend Attachment into place.
Step 3)
Set the stock in the Bender so that the Right Angle Bend Attachment will bend at the first
chalk mark. Bend to 45
.
Step 4)
Make a bend at your second chalk mark to 45
Step 5)
Take the stock out of the Bender. Insert the second side. Repeat steps 3 and 4.
Step 6)
Mark off 1" on the 3" blank.
Step 7)
Set the blank into the Bender at the chalk mark. Bend to 90
Step 8)
Weld the 1" side of the 3" piece to the bottom portion of the "G" . The longer side of the 3"
blank will form the inside part of the G.
The Letter "H"
Three blanks are required for this letter:
•
6"
•
6"
•
3-3/4"
Step 1)
Weld the 3-3/4" blank to the center of each 6" blank. Make certain that both 6"
blanks are even with each other.
#31980
°
at the first chalk mark.
3rd
4th
1"
°.
1st Bend
2nd
1st Bend
3-3/4"
1"
°
.
1st Bend
1"
°.
Page 19
Advertisement
