Connecting Up Ptp-Sync - Motorola PTP-SYNC Installation Manual

5. Installing PTP-SYNC

Connecting up PTP-SYNC

To connect the PTP-SYNC to the PIDU, ODU, GPS receiver (if fitted), and LPU (if fitted),
proceed as follows:
1
Disconnect the power supply from the
PIDU.
2
If using GPS, connect the cable from the
GPS unit to the GPS/SYNC IN port.
3 To link clustered PTP-SYNC units, connect
the SYNC OUT port of the first PTP-SYNC
to the GPS/SYNC IN port of the second
PTP-SYNC in the chain. Repeat for
subsequent PTP-SYNC units in the chain.
4 Connect the cable from the PIDU to the
PIDU IN port. A suitable 1 meter cable is
included in the PTP-SYNC kit.
5
Connect the cable from the ODU to the
ODU OUT port.
6
Use a grounding cable to connect the
ground stud of the PTP-SYNC to the
master ground bar of the building, or to
the rack ground bar.
phn-1613_008v000 (Jun 2011)
PTP-SYNC Installation Guide
Page 20