Table of Contents
Advertisement
Water Connections continued-
Upright Models (See Figures 1A & 1B)
The hot and cold w ater connections are identified on the top of the
w ater heater (See figure 1A). For bottom inlet models (-503 models), the
cold w ater inlet is located on the side of the drain valve (see figure 1B).
Connect the hot and cold w ater lines to the installed nipples using
unions. Install a listed temperature-pressure relief valve in the opening
on the side of the w ater heater.
Figure 1A (Top Inlet Models)
Figure 1B (Bottom Inlet Models)
11
Advertisement
Table of Contents
