Digital Input Signal Formats; Correcting Sound And Picture Sync - Onkyo HT-SR750 Instruction Manual

Advanced Setup—Continued

Digital Input Signal Formats

The following table shows the display indicator for each
digital signal format.
Format
Dolby Digital
DTS
PCM
Normally, the AV receiver detects the signal format auto-
matically. However, if you experience either of the fol-
lowing issues when playing PCM or DTS material, you
can specify the signal format as either PCM or DTS:
• If the beginnings of tracks from a PCM source are cut
off, try the PCM setting.
• If noise is produced when fast forwarding or reversing
a DTS CD, try the DTS setting.
STANDBY/ON
STANDBY
MULTI CH DVD
PHONES
DISPLAY DIGITAL INPUT TONE
DIGITAL INPUT
1
Press and hold the AV receiver's
[DIGITAL INPUT] button for about
DIGITAL INPUT
3 seconds.
2
While "Auto" is displayed (about
3 seconds), press the [DIGITAL
DIGITAL INPUT
INPUT] button repeatedly to
select: PCM, DTS, or Auto.
58
Display
PCM
TUNING PRESET
VCR/DVR CBL/SAT AUX TAPE TUNER C D SETUP ENTER RETURN
SETUP MIC VIDEO
STEREO LISTENING MODE DIMMER MEMORY TUNING MODE
CLEAR
PCM: Only PCM format input sig-
nals will be heard. If the input
signal is not PCM, the PCM
indicator will flash and there
will be no sound.
DTS: Only DTS format input sig-
nals will be heard. If the input
signal is not DTS, the DTS
indicator will flash and there
will be no sound.
Auto (default): The format is
detected automatically. If no
digital input signal is present,
the corresponding analog input
is used instead.

Correcting Sound and Picture Sync

When using progressive scanning on your DVD player,
you may find that the picture and sound are out of sync.
With this setting, you can correct this by delaying the
audio signals. You can set it from 0 to 100 milliseconds
(ms) in 20 millisecond steps.
INPUT
SELECTOR
MASTER VOLUME
AUX INPUT
L AUDIO R
1
RECEIVER
2
1 2
VCR/DVR CBL/SAT
4
AUX
3
Note:
• This setting is not available when the Direct listening
mode is used with an analog input signal.
STANDBY/ON REMOTE MODE
RECEIVER DVD
TAPE/AMP
INPUT SELECTOR M D/CDR
C D
1 2 3
DOCK
V CR/DVR CBL/SAT
TV
4 5 6
AUX MULTI CH DVD
7 8 9 VCR
TAPE TUNER C D
CABLE
10 11 12
+ 10
0 CLR SAT
D TUN ENT
--/--- DIMMER SLEEP
CH
T V VOL VOL
DISC
ALBUM
INPUT
GUIDE PREVIOUS
TOP MENU MENU
SP A / B MUTING
ENTER
PLAYLIST/CAT PLAYLIST/CAT
SETUP RETURN
Press the [RECEIVER] REMOTE
MODE button.
Press and hold, for more than 4
seconds, the input selector but-
ton for the input source that you
want to correct.
6
DVD
This can be the [DVD], [VCR/DVR],
[CBL/SAT], or [AUX] input source.
Use the Left and Right [
buttons to adjust the delay from 0
to 100 milliseconds in 20 milli-
second steps.
RECEIVER
]/[ ]