Advanced Setup; Advanced Speaker Settings - Onkyo HT-SR750 Instruction Manual

Advanced Setup

Advanced Speaker Settings

This section explains how to check the speaker settings
and how to set them manually, which is useful if you
change a speaker after performing the automatic speaker
setup.
Some speaker settings are set automatically by the Auto-
matic Speaker Setup function (see page 36).
By default, the Speaker Configuration and Crossover
Frequency settings are already configured for use
with the speakers included in this home theater sys-
tem, so you only need to change them if you use dif-
ferent speakers.
Speaker Configuration
If you're using speakers other than those included with
this home theater system, use these settings to specify
which speakers are connected and their sizes.
These settings are set automatically by the Automatic
Speaker Setup function (see page 36).
For speakers with a cone diameter
larger than 6-1/2 inches (16 cm),
specify Large (full band). For those
with a smaller diameter, specify
Small (default crossover 100 Hz).
The crossover frequency can be
changed on page 54.
1 Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
RECEIVER
SETUP
2
Use the Up and Down [
buttons to select "Sp Config,"
and then press the [ENTER] but-
ton.
3
While the Subwoofer setting is
selected, use the Left and Right
[ ]/[ ] buttons to select Yes or
No.
Yes: Select if a subwoofer is con-
nected.
No: Select if no subwoofer is con-
nected.
4
5
Cone diameter
6
]/[ ]
Note:
• These settings cannot be changed while headphones
are connected, or the multichannel DVD input is being
used.
Use the Down [ ] button to
select "Front," and then use the
Left and Right [ ]/[ ] buttons to
select Small or Large.
Small: Select if the front speakers are
small.
Large: Select if the front speakers are
large.
Note:
• If the Subwoofer setting in step 3 is
set to No, this setting is fixed at Large
and does not appear.
Use the Down [ ] button to
select "Center," and then use the
Left and Right [ ]/[ ] buttons to
select Small, Large, or None.
Small: Select if the center speaker is
small.
Large: Select if the center speaker is
large.
None: Select if no center speaker is
connected.
Note:
• If the Front setting in step 4 is set to
Small, the Large option cannot be
selected.
Use the Down [ ] button to
select "Surround," and then use
the Left and Right [ ]/[
tons to select Small, Large, or
None.
Small: Select if the surround speak-
ers are small.
Large: Select if the surround speak-
ers are large.
None: Select if no surround speakers
are connected.
Note:
• If the Front setting in step 4 is set to
Small, the Large option cannot be
selected.
Continue with step 7 of the "Crossover
Frequency" setting on the next page.
] but-
53