Onkyo HT-SR750 Instruction Manual page 37

First Time Setup—Continued
Using Audyssey 2EQ
1
STANDBY/ON
STANDBY
MULTI CH DVD VCR/DVR CBL/SAT AUX
PHONES
DISPLAY DIGITAL INPUT TONE STEREO LISTENING MODE
2, 6
1 Turn on the AV receiver.
2 Put the speaker setup microphone at
measurement point
connect it to the SETUP MIC jack.
SETUP MIC
Notes:
• Make sure the microphone is horizontal.
• If there's an obstacle between the micro-
phone and any speaker, the automatic setup
will not work correctly. Set up the room as
you would when enjoying a DVD.
• Positioning the microphone close to where
your ears would normally be will provide
better results. You can adjust the height of the
microphone by using a tripod or level table.
3 Press [ENTER].
The automatic speaker setup starts.
A test tone is output by each speaker in turn, as
the Audyssey 2EQ function determines which
speakers are connected. This takes a few min-
utes.
Note:
• If any extraneous noise is picked up by the
microphone, the automatic setup may not
work correctly, so don't make any noise.
MASTER VOLUME
TUNING PRESET
TAPE TUNER C D SETUP ENTER RETURN
AUX INPUT
SETUP MIC VIDEO L AUDIO R
DIMMER MEMORY TUNING MODE
CLEAR
SETUP MIC
1
(page 36), and
Notes:
• If the AV receiver was previously muted, it will
be unmuted.
• Automatic speaker setup cannot be performed
while a pair of headphones is connected.
• It takes about 10 minutes to complete the auto-
matic speaker setup.
4 When the following display appears,
move the speaker setup microphone to
measurement point
then press [ENTER].
Audyssey 2EQ performs more measurements.
This takes a few minutes.
5 When the following display appears,
move the speaker setup microphone to
measurement point
then press [ENTER].
Audyssey 2EQ performs more measurements.
This takes a few minutes.
When the measurements are complete, the
results are calculated and saved automatically.
6
When the automatic speaker setup is
complete, disconnect the speaker setup
microphone.
Notes:
• When the automatic speaker setup is complete, the
Equalizer Settings (page 57) will be set to "Audyssey."
• You can cancel the automatic speaker setup at any
point in this procedure simply by disconnecting the
setup microphone.
2
(page 36), and
3
(page 36), and
37