Table of Contents
Advertisement
Turning on
Connecting the POWER
The DV-S353 is shipped with the main power (POWER) switch in the
on position (
ON). When the power cord is plugged in for the first
time, the DV-S353 will automatically enter the standby mode and the
STANDBY indicator will light (same condition after step 2 below).
POWER
STANDBY/ON
STANDBY indicator
1
Plug the power cord into
the power outlet on the
wall.
2
Press POWER to switch
on the main power.
The DVD Player enters standby mode.
The STANDBY indicator lights up.
Notes
• The buttons on the remote controller do not operate if
the POWER switch is set to OFF.
• To switch off the main power, press POWER again.
3
Press
STANDBY/ON
on the DVD Player or
remote controller.
The DVD Player turns on and the STANDBY
indicator turns off.
Notes
• You can turn on the DVD player by pressing 0 or £/8.
• To put the DVD Player in the standby mode, press
STANDBY/ON on the DVD Player, or remote
controller. Be sure to set the volume to minimum
before putting the DVD Player in the standby mode for
the next use to avoid sudden loud sound reproduction.
• While the STANDBY indicator lights up, the DVD
Player can receive signals from the remote controller.
However, if you press POWER on the DVD Player to
switch off the main power, the remote controller
cannot be used to turn on the DVD Player.
• Setting the STANDBY button to standby does not shut
off the power completely.
Notes
• Make sure that all appropriate connections have been completed
as described on pages 14 to 16.
• Turning on the DVD Player may cause a momentary power surge,
which might interfere with other electrical equipment such as
computers. To prevent interference, use a wall outlet on a different
circuit.
STANDBY/ON
17
Advertisement
Table of Contents
