Setup Codes For Video Accessories - One for All URC-9910 User Manual

6.
7.
8.
9.
(Optional) Skip this step if your TV/VCR Combo
does not have a separate TV code. Otherwise, press
TV once.You will see the display change to [TV] and
its current code.
Use the keypad to enter the separate TV code for
your device.
Press EXIT to exit the programming mode.You will
see [EXIT SETUP] as the URC-9910 remote control
returns to normal operation.
To verify the code works, aim the URC-9910 remote
control at the desired device, press VCR once and
then press POWER once. The TV/VCR Combo
should turn off. If it does not respond, repeat steps 2
through 8, trying each code for your brand until you
find one that works. If it still does not work, try
Searching For Your Code on page 27.
NOTE: If the device does not have a POWER key, press the
( Play ) key.
NOTE: For VCR/TV Combos programmed with separate TV
codes, TV volume is controlled by pressing
TV
. After that, use VOL+ (or VOL- ) to raise (or lower)
then
the TV volume. For other alternatives on controlling volume
keys, see "Changing Volume Lock" on page 32 or "Using
Keymover" on page 38.
For future reference, write down the working
TV/VCR combo code in the below boxes:
TV/VCR Code:
TV Code
(if used):
13
VCR
first and