Source Menu; Other Features - JVC InteriArt LT-20DA6SK Instructions Manual

automatically on your TV, according to the
transmission of programme systems in
your area.
First of all choose the “Country” by using
“ ” or “ ” button. Then press the Red but-
ton to start Autostore.
After Autostore is finalized, a programme list
will appear on the screen. In the program list
you will see the programme numbers and
names assigned to the programmes.
If you do not accept the locations and/or the
programme names of programmes, you
can change them in Programme menu.

Source Menu

You can switch your TV to EXT modes by
pressing directly to “AV” button or by select-
ing in source menu from the main menu.
While in EXT mode, you can also switch your
TV to TV or other EXT modes by selecting in
source menu from the main menu.
In main menu, firstly use “
then use “ ” / “ ” or “OK” button to enter
Source menu. In source menu, move the
cursor by “ ” or “
“OK” button or “ ” / “ ” buttons when the
cursor is on the required item. The selected
mode comes automatically on the screen.
ÃÃÃÃÃÃÃÃÃT‚ˆ…prÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃ)ÃUW
Ã9DBDU6G
ÃUW
@YU
@YU!
@YU!ÃT
@YU"
@YU#
@YU#ÃT
Q8
” or “ ” button
” button and then press

Other Features

TV Status
Programme Number, Programme Name
(or EXT), (they are displayed on the upper
left of the screen). The sound indicator is
displayed with them too. They are displayed
after programme change for 3 seconds.
Sound Indicator
The alternatives of the indicator are Mono,
Stereo, Dual I and Dual II. This indicator is
displayed under the programme number in-
dicator on the screen.
In Mono broadcast or in forced-mono (for
stereo broadcast).
In Stereo broadcast.
If dual broadcast detected. Dual I is selected
in default and also can be selected after
Dual II by Remote Control.
If Dual II selected by Remote Control.
Hyper Sound
By selecting Hyper Sound in sound menu or
by pressing the “
control, Pseudo/Spatial effect can be turned
on or off. In Mono transmission the left and
right channels will be added at left channel
and dummy stereo effect will introduced to
end-user.
In stereo transmission it yields a phase dif-
ference between left and right channels.
Mute Indicator
It is placed in the upper middle of the screen
when enabled, and it stays there until it is
disabled.
To cancel mute, there are two alternatives;
the first one is by pressing the “ ” button,
- 33 -
0RQR
6WHUHR
'XDO ,
'XDO ,,
” button on your remote