Advertisement
4.
Stand the T4850CT on its back and grasp the computer with your hand covering
the base assembly. While holding the computer with one hand to steady it and to
protect the base assembly, remove two M2.5x6 silver screws and one M2.5x12
silver screw on the bottom of the computer (Figure 4-29).
Figure 4-29 Removing the screws securing the base assembly
5.
Remove the back left I/O port cover and open the right I/O port cover (Figure 4-
30).
6.
Remove the M2.5x6 screw at the left front corner securing the base assembly to
the bottom cover (Figure 4-30).
7.
Press the FDD eject button so that it clears the bottom cover and lift up the front
of the base assembly (Figure 4-30).
8.
After lifting up the front of the base assembly, pry the I/O port frame slightly
away from the base assembly to separate the base assembly from the bottom cover,
then lift the assembly out of the cover. (Figure 4-30).
T4850CT
Figure 4-30 Removing the base assembly
4-29
Advertisement
