Using A Telnet Session To Access The Cli - Cisco Aironet 350 Series Hardware Installation Manual

Using a Telnet Session to Access the CLI

Using a Telnet Session to Access the CLI
Follow these steps to browse to access the CLI using a Telnet session. These steps are for a PC running
Microsoft Windows with a Telnet terminal application. Check your PC operating instructions for
detailed instructions for your operating system.
Step 1 Choose Start > Programs > Accessories > Telnet.
If Telnet is not listed in your Accessories menu, choose Start > Run, type Telnet in the entry field, and
press Enter.
Step 2 When the Telnet window appears, click Connect and choose Remote System.
Note
In the Host Name field, type the access point's IP address and click Connect.
Step 3
Hardware Installation Guide for Cisco Aironet 350 Series Access Points Running Cisco IOS Software
3-14
D r a f t 1 - C I S C O C O N F I D E N T I A L
In Windows 2000, the Telnet window does not contain drop-down menus. To start the Telnet
session in Windows 2000, type open followed by the access point's IP address.
Chapter 3 Basic Configuration
OL-7467-01