Cisco Aironet 350 Series Hardware Installation Manual page 32

Connecting the Ethernet and Power Cables
Connect the other end of the Ethernet cable to the device that will supply power.
Step 3
If you use a power injector, follow these additional steps:
Plug the cable from the access point into the end of the power injector labeled To AP/Bridge.
a.
Run an Ethernet cable from the end of the power injector labeled To Network to the 10/100 Ethernet
b.
switch.
Plug the female end of the power cord into the universal power supply.
c.
Plug the male end of the power cord into a power outlet or power strip.
d.
At start-up, all three LEDs on the top of the access point slowly blink amber, red, and green in sequence;
the sequence takes a few minutes to complete. During normal operation, the LEDs blink green. Refer to
Chapter 6, "Troubleshooting,"
Follow the steps in
Step 4
Hardware Installation Guide for Cisco Aironet 350 Series Access Points Running Cisco IOS Software
2-8
D r a f t 1 - C I S C O C O N F I D E N T I A L
for LED descriptions.
Chapter 3, "Basic Configuration," to assign basic settings to the access point.
Chapter 2 Installation
OL-7467-01