Epson Apex User Manual page 38

2. Type:
DISKCOPY A: B:
and press
Enter.
Insert SOURCE diskette in drive A:
Insert TARGET diskette in drive B:
Press any key when ready...
3. Insert the MS-DOS system diskette you want to copy (the
source) into drive A.
4. Insert a blank 5 l/4-inch, 360 KB diskette (the target) in
drive B, the bottom disk drive, and close the diskette drive
latch.
5. Press any key to begin the copy process. If the diskette in
drive B is not formatted, the DISKCOPY program formats
it. Then the program copies the data from drive A to the
formatted diskette in drive B.
When the copy is complete, the screen displays the
following prompt:
Copy another diskette? (Y/N)
6. Press Y so you can make a copy of the diskette containing
GW-BASIC. Remove the diskettes from drives A and B
(turn the latch on each drive to remove the diskette).
Then insert the GW-BASIC diskette in drive A and
another blank diskette in drive B. Follow the prompts to
copy this system diskette.
When the copy is complete, this prompt displays again:
Copy another diskette? (Y/N)
The screen displays these prompts:
Setting Up Your System
1-23