5-2 System Error Messages - Datatech Enterprises Apex 386SX/20 User Manual

5-2 System Error Messages

Basically there are three levels of system error messages that you
might see displayed on your computer. These are related to the
software you use. The following are the ones most commonly en-
countered.
Software error messages are a result of:
Hardware error messages:
These messages are related to the computer's internal components,
your monitor, mouse, or printer. Hardware problems are usually ones
that the user cannot solve alone. Professional services are therefore
required.
Error messages generated by MS-DOS, BASIC or other
high-level applications:
These messages relate to problems due to incorrect use or malfunc-
tion of a high-level application under which you might run your
software. It is still advisable to contact your software dealer for assis-
tance with such problems.
Consult
4
Chapter 5: Troubleshooting
Ž
Software lockup;
cursor will not move. When this happens, remove your ap-
plication program from the disk drive (unless a hard disk is
used) and reboot your computer. If the problem persists,
contact your nearest software dealer.
Ž Software crash;
text on the monitor or the cursor locks up. Try to reboot the
computer. If the problem persists, you will need to contact
the software dealer from whom you purchased the package.
He/she should replace the package, depending on the ser-
vice contract, or have it repaired.
your dealer if you have any questions
the application becomes stuck and the
the application suddenly displays garbled
about
troubleshooting.