3-3 Hard Disk Drive Format; Step 1 - Preformat; Step 2 - Partition - Datatech Enterprises Apex 386SX/20 User Manual

3-3 Hard Disk Drive Format

A hard disk must be formatted before it can be read from or written to.
If your hard disk requires this, you should carry out the following steps:
S t e p 1 — Preformat
The preformat utility is supplied by the system BIOS. You can press
<E
Choosing item 2 from the initial screen to preformat hard disk. See
Figure 3-1.
Step 2 — Partition
This process creates DOS partitioning on a preformatted hard disk
drive. The DOS command "FDISK" handles this partitioning process.
Insert your DOS diskette in drive A and type a: to get A prompt. Then
type:
The "FDISK" command displays a serial of menus to help you partition
your hard disk for MS-DOS. With the "FDISK" command, you can:
If your hard disk is 40MB, you may have partitions of up to 33MB in
size. 33MB is the maximum space for a partition allowed by DOS.
For more information about how to use creating DOS partition, see
Appendix D in MS-DOS User's Guide and Reference.
8 Chapter 3: Operating Your System
just
> key quickly
SC
A> FDISK < 8 >
create a primary partition,
l
. create an extended partition,
change the active partition,
l
delete an partition,
l
display partition data, and
l
. select the next fixed disk drive for partitioning on a system
with multiple fixed disks.
after the RAM test to enter the SETUP program.