Epson PowerLite 62c User Manual page 90

Solving Problems
90
The video signal may be split between the computer and the
■
projector. If you notice a decline in the projected image quality
when the image is displayed simultaneously on your laptop
computer and the projector, turn off the laptop's LCD display.
If you're projecting from a composite or S-Video source, check
■
the
Video Signal
it set at . If you're using a 60-Hz PAL video source, change
Auto
this setting to
PAL60
Make sure the cables are securely connected at both ends.
■
■ Select the correct resolution; see "Compatible Video Formats" on
page 100.
■ If you're projecting from a computer, press the
the remote control or the
tracking and sync automatically. If that doesn't work, try
adjusting the
Sync
page 59.
The image is blurry.
Adjust the focus using the focus ring.
■
Make sure the lens cap is off.
■
■ There may be dirt or smears on the lens. Clean the lens as
described on page 74.
Make sure the lens is not fogged by condensation. You may need
■
to wait before using the projector after moving it from a cold
environment.
Make sure the projection distance is within the range described on
■
page 16.
Adjust the
■
Sharpness
You should be able to see the effect on the screen immediately.
setting in the Signal menu. In most cases, leave
. See page 60 for details.
button on the projector to adjust
Enter
and settings in the Signal menu. See
Tracking
setting on the Image menu (see page 57).
button on
Auto