Maintenance - Husqvarna 360BT Operator's Manual

Introduction
WARNING:
the safety chapter before you do
maintenance on the product.
Maintenance schedule

Maintenance

Clean the external surfaces.
Make sure that the control handle operates correctly.
Make sure that the start/stop switch operates correctly. Refer to
check of the start/stop switch on page 6 .
Examine the engine, the fuel tank and the fuel lines for leaks. Examine the
fuel filter for contamination. Replace the fuel filter if it is necessary.
Clean the air filter. Replace the air filter if it is necessary.
Tighten nuts and screws.
Examine the air intake and make sure that it is not blocked.
Examine the starter and the starter rope for damages.
Examine the vibration damping units for damages, cracks and deformation.
Make sure that the vibration damping units are correctly installed.
Examine the spark plug. Refer to
11 .
Clean the cooling system.
Clean the external surface of the carburetor and the area around it.
Clean the fuel tank.
Examine all cables and connections.
Examine and clean the spark arrestor screen on the muffler (for products
without catalytic converter).
Examine and clean the spark arrestor screen on the muffler (for products
with catalytic converter).
Examine the spark plug. Replace if it is necessary.
To adjust the idle speed
1. Make sure that the air filter is clean and that the
air filter cover is attached.
2. Adjust the idle speed with the idle speed screw.
To see where the idle speed screw is on your
Product overview (360BT) on
product, refer to
page 2 .
1967 - 001 - 20.01.2023
Maintenance
Read and understand
To do a check of the spark plug on page
To do a
To do a check of the spark plug
CAUTION:
spark plug. Refer to
page 16 . An incorrect spark plug can
cause damage to the product.
1. Stop the engine and let the product become cool.
2. Clean the spark plug if it is dirty.
Daily Weekly Monthly
X
X
X
X
X
X
X
X
X
X
X
X
X
Use the recommended
Technical data on
X
X
X
X
11