Safety - Husqvarna W25P Operator's Manual

Symbols on the product
Hot surface
The port to refuel the MIX GASO-LINE
The direction to close the choke
The direction to open the choke
Primer
Low speed
High speed
Safety definitions
The definitions below give the level of severity for
each signal word.
WARNING: Injury to persons.
CAUTION: Damage to the product.
Note: This information makes the product easier to
use.
General safety instructions
WARNING: Read the WARNING
instructions that follow before you use the
product.
• Use the product correctly. Injury or death is a
possible result of incorrect use. Only use the
product for the tasks found in this manual. Do not
use the product for other tasks.
• Read, understand and follow the instructions and
the symbols in this manual. If the operator does not
follow the instructions and the symbols, injury,
damage or death is a possible result.
Note: Other symbols/decals on the product refer to
certification requirements for other commercial
areas.
Product liability
As referred to in the product liability laws, we are
not liable for damages that our product causes if:
• the product is incorrectly repaired.
• the product is repaired with parts that are not from
the manufacturer or not approved by the
manufacturer.
• the product has an accessory that is not from the
manufacturer or not approved by the manufacturer.
• the product is no repaired at an approved service
center or by an approved authority.

SAFETY

• Do not discard this manual. Use the instructions to
assemble, to install attachments and accessories,
to operate and to keep the product in good
condition. Only use approved attachments and
accessories.
• It is not possible to give WARNING on every
situation that can occur during operation and
maintenance of the product. Always be careful and
use your common sense.
• Make sure that parts are not damaged before you
use the product. Follow the maintenance schedule.
Only do the maintenance work that instructed in
this manual. An approved service center must do
all other maintenance work.
• Do not operate the product or do maintenance on
the product if you are not sure of the situation. Turn
to the approved dealer, service agent or service
center for information.
• Disconnect the spark plug cable before assembly,
storage or maintenance of the product.
• Do not use the product if it is changed from its
initial specification. Do not change any part of the
product without approval from the manufacturer.
Only use parts approved by the manufacturer.
Injury or death is a possible result of incorrect
maintenance.
3