KYMCO PEOPLE S 50 Manual page 16

1
Service indicator: It lights up every 2000km
to remind you to do oil service. Whenever
the ignition switch is turned on, it goes on
then off after self-diagnose.
2
ABS indicator: It lights up when the ignition
switch is turned on and will turn off after the
vehicle starts moving. It will stay off as long
as the ABS system works normally.
3 High Beam Indicator Light: This light is
illuminated when the high beam is on.
4 CELP indicator: If it keeps on after starting
the engine, it indicates that a fault has
been detected in the EFI or electrical
system. It needs immediate inspection by
the authorized KYMCO dealer.
NOTE: Turn on the ignition switch, The CLEP
indicator will always illuminate. After starting it will be
off.
5 Tachometer: Indicates the engine revolution
speed in RPM.
6
Fuel Warning Indicator "
when the fuel tank is nearly empty ,it alerts
the rider to refill the fuel tank as soon as
possible.
12
CONTROLS & FEATURES
" It will be on :
7
Turn Signal Indicator Light: Flashes when
either turn signal is being used.
8
Odometer/Trip meter:
Press MODE button to toggle between ODO
mode, Trip mode and oil service ( blank
mode)
Choose Trip or oil service mode, hold both
MODE and ADJ for 2 seconds to reset.
Press ADJ to switch between km display
and mile display.
9 Speedometer: Indicates the road speed in
km/h or mph.
10 Battery Voltage and Digital Clock(without
noodoe):
It displays the battery voltage or clock.
11 USB Charging Indicator:
Plug electronic device in, the indicator will
be ON when it is charging, it will be OFF
when it is not charging. It will flash when the
battery voltage is too low. The circuit will be
cut off if the electric current is overload to
protect your device.