Curve - TBEA TS208KTL-HV Series User Manual

⚫
⚫
⚫
5.3 逆 变 器 温 度 降 额 曲 线 设 计 Design of Inverter
Temperature Reduction Curve
逆变器的正常运行需要一定的温度条件。 在环境温度高于最低温
度降额点时，输出功率随着温度的升高而线性下降；如果环境温度大
于逆变器允许的最高运行温度时，逆变器则关机。当温度降低到温度
降额点时，机器恢复正常工作。
A certain temperature condition is required for the inverter to operate normally.
When the external ambient temperature is above the minimum temperature derating
point, the output power decreases linearly with increasing temperature; The inverter is
shut down when the ambient temperature is greater than the maximum operating
temperature allowed by the inverter. When the temperature drops to the temperature
derating point, the inverter resumes the normal operation.
During fault of the system, the fault light of the indication
panel will light up to give an alarm and the corresponding
fault information may be read via an upper computer;
在进行故障排除前，应将直流开关关闭，并且断开逆变
器与电网之间的断路器， 根据 5.3 节中的方法进行故障排
除。
Prior to troubleshooting, the DC switch shall be turned off
and the breaker between the inverter and grid shall be
disconnected. Troubleshooting shall be performed according
to the method in Section 5.3.
72