通讯地址设置 Setup Of Communication Address - TBEA TS208KTL-HV Series User Manual

（1） 确认交流输出线缆、 地线、 通信线等连接正确并安装牢靠。
（2）确认没有工具以及其他杂物遗留在逆变器内部。
（3）关闭前门板并安装好门板上的螺丝，紧固力矩为6 N·m。
（4）清理现场。
（1）Confirm that the
communication cable are connected correctly and installed firmly
（2）Confirm that no tools and others are left inside the inverter.
（3） Close the front door panel and install the screws on the door
panel. The tightening torque is 6N·m.
（4）Clean up the site.
4.2.7
通讯地址设置 Setup of communication address
⚫
通信地址设置 Setup of communication address
1） APP设置方式 Set up by APP
手机 APP 连接该逆变器的热点，选择"更多---通讯参数---设备地
址" ，设置页面如图4-24所示。修改逆变器的通讯地址（1-247） ，必须
保证在方阵内唯一，修改后立即生效。
Connect the hotspot of the inverter through mobile
"more-- communication parameters—device address," the setting
interface is as shown in figure 4-24. Modify the communication address
(1-247), guaranteed to be unique within the arrays, effective immediately
after amendment
output cable, grounding wire and
AC
64
, select
APP