Siemens SIMATIC NET CP 1542-5 Equipment Manual page 4

Preface
Abbreviations and reference to the module version
• CP / module / device
These terms are used in the following instead of the complete product designation. In this
case, the information applies equally to both firmware versions or hardware product
versions of the module.
If the data of the two devices differs, the firmware version or the hardware version of the
respective device is explicitly stated.
• STEP 7
The name STEP 7 is used to mean the STEP 7 Professional configuration tool.
Purpose of the manual
This manual supplements the system manual of the S7-1500 automation system and the
function manuals. All functions that go beyond the system are described in the system
manual.
With the information in this manual and the system manual, you will be able to commission
the CP 1542-5.
New in this edition
• New module with new article number, see above.
• New firmware version improvements to the operating behavior
• New approvals: CCC / UKEX
• Editorial revision
Replaced edition
Edition 11/2018
Manual on DVD
You will find the manual on the DVD supplied with the product. This DVD contains the
product manuals valid at the time it is created.
Current manual edition on the Internet
You will also find the current version of this manual on the Internet pages of Siemens
Industry Online Support:
Link: (https://support.industry.siemens.com/cs/ww/en/ps/15672/man)
Sources of information and other documentation
See section Documentation (Page 9).
4
Equipment Manual, 01/2023, C79000-G8976-C326-05
SIMATIC CP 1542-5