Accept/Reject 1 To - Minelab X-TERRA PRO Instruction Manual

Accept/Reject
You can create your own discrimination patterns
to detect or ignore specific target types, so you
can dig more treasure and less trash�
The Discrimination Scale is made up of 30 individual
segments that correspond to the 119 Target IDs� Each
segment represents 4 Target IDs
Segments can be turned On/Off to either detect (accept)
or ignore (reject) targets� All Target IDs that are On will be
accepted and all Target IDs that are Off will be rejected�
Discrimination patterns are local, only the current Search
Mode Profile Discrimination Pattern will be changed�
CREATING A DISCRIMINATION PATTERN
1. Navigate to the Accept/Reject setting�
2. Use the Minus (–) and Plus (+) buttons to navigate to the
Discrimination Segment you wish to change�
3. The selected Discrimination Segment will flash slowly,
and the Target ID Number of the highest ID represented
by that Segment will be displayed� E�g� the sixth
segment from the left represents Target ID's 1 to 4,
so a 4 is displayed on the Target ID display� Press the
Accept/Reject button to toggle the Segment On/Off�
4. Continue to navigate along the Discrimination Scale,
turning Segment On/Off using the Accept/Reject button
until you have created your discrimination pattern�
CONTENTS
(page 34)�
30
ACCEPT/REJECT TARGETS UPON
DETECTION
A target can be rejected upon detection if the corresponding
Target ID is currently turned On in the discrimination pattern�
If a Target ID is currently Accepted and a detection occurs,
an audio response will be heard, the Target ID segment will
flash, and the Target ID Number will be displayed�
To reject a detected target, press the Accept/Reject button�
Targets with that Target ID will now be rejected, and will not
be heard�
The last rejected target can be instantly re‑accepted by
pressing the Accept/Reject button again, as long as no
other detection occurs before doing so�
Example showing the detection of an accepted non‑ferrous target
with a Target ID of 32� Segment 13 on the Discrimination Scale will
flash, because that Segment represents Target IDs 29 to 32�
Accepting a rejected Target ID is not possible directly
from the Detect Screen� Rejected Target IDs must be
re‑Accepted by adjusting the discrimination pattern via the
Accept/Reject Setting in the Settings Menu�
ALL METAL
All Metal is turned Off by default each time the detector is
powered On�
Turn All Metal On/Off by pressing the
All Metal button�
When All Metal is On, the current discrimination pattern is
disabled so that all metal objects will be detected�