Table of Contents
Advertisement
Assembly
1. To charge the battery, locate the
connector (T, Figure 2-5) that
hangs from the wire harness below
the handlebar console.
2. Plug the connector on the bat-
tery charger (Z, Figure 2-5) into
the connector on the wire harness
(T).
3. Plug battery charger into 120V
grounded wall outlet. NOTE:
Battery charger is designed for use
indoors and should not be exposed
to rain or snow.
4. Charge battery for 24-48 hours.
5. After charging, unplug battery
charger from wall outlet, then un-
plug charger from connector on
wire harness.
STEP 4: Attach Control Rods
WARNING
Control rods are adjusted at
the factory and should not re-
quire additional adjustment
during assembly. After as-
sembling unit, control rod ad-
justment should be checked
(and re-adjusted, if neces-
sary) according to informa-
tion in Maintenance Section.
Severe personal injury or
property damage could result
from not following this
instruction.
A. Attach Wheel Drive Control
Rod
1. Locate the wheel drive control
rod (F, Figures 2-6 & 2-7) that you
removed from the left handlebar in
Step 2. This rod has a swivel block
(H, Figure 2-6) on one end.
2. At left side of engine frame,
insert swivel block (H, Figures 2-6
& 2-7) on wheel drive control rod
into wheel drive control arm (U,
Figure 2-6).
T
Z
To grounded
wall outlet
Figure 2-5: Connect battery charger terminal to wire harness
terminal.
F
Figure 2-6: Left-hand control rods detail.
3. Add one 5/16" washer (A,
Figure 2-6). Secure with cotter
pin (B, Figure 2-6). Bend ends of
cotter pin to secure.
4. At upper end of control rod,
secure angled end to Wheel Drive
Control lever (V, Figure 2-6A),
using a cotter pin (BB). Bend
ends of cotter pin to secure.
10
E
U
H
A B
Figure 2-6A: Attach wheel drive
control rod to lever.
W
G
T
BB
V
Advertisement
Table of Contents
