Advertisement
3.
Assembly Instructions
Tools Needed:
7/16 in., 3/4 in.
17
2
11
19
18
Phillips Screwdriver
9
3
10
21
1
20
12
16
13
8
15
6
24
23
4
14
5
Slide Axle (5) thru axle holes on
Frame Rails (1).
Attach Bottom Tray (4) to Frame
Rails using two #10 Phillips screws
(15).
Attach Top Tray (3) to Frame Rails
(1) using four #10 Phillips screws
(15).
Attach casters (12) using washer
(20) and nut (21). Use 3/4 in.
wrench to tighten.
Install spacers (24) over each end
of Axle (5). Slide wheels (7) onto
Axle (5) . Lightly tap Retaining
Rings (22) into slots on each end of
Axle.
Attach Bottle Support Bracket (8) to
Rear Mounting Frame (6) using
three No. 10 Phillips Screws (15).
Attach Rear Mounting Frame (6) to
Frame Rails (1) using screw (16),
washer (18), and nut (19) . Hand−
tighten all hardware. Use 7/16 in.
wrenches to tighten completely.
Attach Consumable Tray Bracket
(11) to Frame Rails (1) using
screws (16), washers (18) and nuts
(19). Hand-tighten all hardware.
Use 7/16 in. wrenches to tighten
completely.
Attach Cable Hangers (9) to Handle
(2) and Rear Mounting Frame (6)
using eight No. 10 Phillips screws
(15).
Attach Handle (2) to Frame Rails
(1) using screw (16), washer (18),
and nut (19). Hand−tighten all hard-
ware. Use 7/16 in. wrenches to
7
tighten completely.
22
Lightly tap four Tubing Plugs (23)
into the exposed ends of Rear
Mounting Frame (6) and Frame
Rails (1).
Be sure that all hardware is tight,
then place welding power source
onto cart.
Attach Locking Tab (10) to Top Tray
(3) by loosely installing two screws
(17), washers (18), and nuts (19).
Slide locking tab against front panel
of power source to secure welding
power source to cart. Tighten the
hardware using 7/16 in. wrenches.
Slide Plastic Box (not shown) into
Consumable Tray Bracket (11).
Connect Chain (13) to slots in Bottle
Support Bracket (8).
.
If using a small shielding gas
bottle, install Chain (13) into
slots in Top Tray (3).
OM-269238 Page 3
Ref. 269249-D
Advertisement
